While in the B1 or B2 settings, the needle is hesitant while coming out of the fabric, causing the needle to flex or even break. How can I correct this?

ANSWER:

The needle return position is too low, the needle stops short of the proper "up" position, and the "auto pull-up" is activated.You need to move the needle return position (Page 10.) forward. The proper needle return position is when the take-up lever stops about 1/4" below the "needle up" position.

NOTE:
If the above problems show up in Precision Mode, you should adjust the precision needle return position (Pages 11,12) the same way.

Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk